Garland MULE 961 QG Manuel D'instructions page 43

6.2.2. ASSEMBLING THE MILLING CUTTERS
Warning! The cutting edge of the blade must be in
the direction of the rotation of the milling cutters.
The machine comes with the inner tills mounted the
wrong way around to minimize space, see figure S1.
Remove the inner tills and fix them as shown in figure
S2.
The tills are fixed with the pins Q shown in the figure.
Now fix the outer tills (R2) fixing them with the pins
provided.
Finally, on the outermost place the plant protecting
discs (R3) fixing them with the pins provided.
Attention: The cutting edge of the blade must be
placed in the direction of the rotation of the tills.
6.2.3. MOUNTING THE PROTECTOR
Install the exterior protectors
with the M8X25 screws
provided as per the figure.
Note: To install the left protector, you will need to open
the belt cover so as to have access to the screws.
6.2.4. MOUNTING THE TRANSPORT WHEEL
Place the transport wheel as shown in the figure fixing
the wheel with the M8x50 screw provided.
Install the spring (l) holding it with the steel studs (w).
43/184
English