Publicité
16
www.aeg.com
Problem
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
Residual heat indicator does
not come on.
Hob²Hood does not work.
Automatic Heat Up does not
operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no sound when you
touch the panel sensor
fields.
comes on.
comes on.
comes on.
Possible cause
You put something on one
or more sensor fields.
The zone is not hot because
it operated only for a short
time or the sensor is dam-
aged.
You covered the control
panel.
The zone is hot.
The highest heat setting is
set.
Power management oper-
ates.
The cookware is too large or
you put it too near to the
controls.
The sounds are deactivated.
Automatic Switch Off oper-
ates.
Child Safety Device or Lock
operates.
There is no cookware on the
zone.
The cookware is unsuitable.
The diameter of the bottom
of the cookware is too small
for the zone.
Remedy
Remove the object from the
sensor fields.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Remove the object from the
control panel.
Let the zone become suffi-
ciently cool.
The highest heat setting has
the same power as the func-
tion.
Refer to "Daily use".
Put large cookware on the
rear zones if possible.
Activate the sounds. Refer to
"Daily use".
Deactivate the hob and acti-
vate it again.
Refer to "Daily use".
Put cookware on the zone.
Use suitable cookware. Refer
to "Hints and tips".
Use cookware with correct
dimensions. Refer to "Tech-
nical data".
Publicité
