Télécharger Imprimer la page

EuroLite TC-5 Mode D'emploi page 26

Publicité

Les langues disponibles

Les langues disponibles

Please note: If you wish to change from one operating mode into another, you have to unplug the projector
from the mains and plug it again.
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. In order to call up the different features, you first have to open the dimmer
(control channel 2, DMX-value 255).
Addressing
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the TC-5 will respond to the controller.
If you set, for example, the address to channel 3, the TC-5 will use the channel 3 to 4 for control.
Please, be sure that you don't have any overlapping channels in order to control each TC-5 correctly and
independently from any other fixture on the DMX data link.
If two, three or more TC-5 are addressed similarly, they will work similarly.
For address setting, press the Up/Down-buttons until the display shows "A001" and set the desired address
via the Yes/No-buttons. Confirm with Enter.
Controlling:
After having addressed all TC-5, you may now start operating these via your lighting controller.
Note:
After switching on, the TC-5 will automatically detect whether DMX 512 data is received or not. If the data is
received, the control LED flashes. If there is no data received at the DMX-input, the control LED lights up
permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the TC-5.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX-protocol
Control channel 1 - Color-wheel
Linear color change following the movement of the slider. In this way you can stop the color-wheel in any
position.
Decimal Hexad. Percentage S/F
0 9
00 09
0% 4%
10 20
0A 14
4% 8%
21 31
15 1F
8% 12%
32 41
20 29
13% 16%
42 52
2A 34
16% 20%
53 63
35 3F
21% 25%
64 73
40 49
25% 29%
74 84
4A 54
29% 33%
85 95
55 5F
33% 37%
96 105
60 69
38% 41%
106 116
6A 74
42% 45%
117 128
75 80
46% 50%
129 190
81 BE
51% 75%
191 193 BF C1
75% 76%
194 223 C2 DF
76% 87%
224 225
E0 E1
88% 88%
226 255
E2 FF
89% 100%
S Closed
S White
S Green
S Red
S Cyan
S Bright green
S Magenta
S Bright blue
S Yellow
S Green
S Deep rose
S Blue
S Scroll
S Sound-controlled
F Forwards rainbow effect with decreasing speed
S No rotation
F Backwards rainbow effect with increasing speed
26/53
Feature
00026765.DOC, Version 1.3

Publicité

loading