Makita DTW1001RTJ Manuel D'instructions page 10

NOTE: If the drill bit is not inserted deep enough into
the sleeve, the sleeve will not return to its original
position and the drill bit will not be secured. In this
case, try re-inserting the drill bit according to the
instructions above.
NOTE: After inserting the drill bit, make sure that it is
firmly secured. If it comes out, do not use it.
Ring
Only for Model DTW800
► Fig.13: 1. Bracket 2. Ring 3. Screws
The ring is convenient for hanging the tool with hoist.
First, place the rope through the ring. Then hang the
tool up to the air with hoist.
CAUTION:
Before using the ring, always
make sure that the bracket and ring are secured
and not damaged.
Installing hook
► Fig.14: 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool. To install
the hook, insert it into a groove in the tool housing
on either side and then secure it with two screws. To
remove, loosen the screws and then take it out.
OPERATION
CAUTION:
Always insert the battery cartridge
all the way until it locks in place. If you can see
the red part on the upper side of the button, it is not
locked completely. Insert it fully until the red part can-
not be seen. If not, it may accidentally fall out of the
tool, causing injury to you or someone around you.
►Fig.15
Hold the tool firmly and place the impact socket over
the bolt or nut. Turn the tool on and fasten for the proper
fastening time.
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
Model DTW1001
Proper fastening torque for standard bolt
2
N•m
(kgf•cm)
800
(8160)
600
(6120)
400
(4080)
200
(2040)
0
0
1. Fastening time (second) 2. Fastening torque
Proper fastening torque for high tensile bolt
2
N•m
(kgf•cm)
800
(8160)
600
(6120)
400
(4080)
200
(2040)
0
0 1
1. Fastening time (second) 2. Fastening torque
9 ENGLISH
M30(1-1/4")
M30(1-1/4")
M24(1")
M24(1")
1 2 3
1
M24(1")
M22(7/8")
M20(3/4")
2 3 4 5
1
M24(1")
M22(7/8")
M20(3/4")
6