Bosch CM12SD Consignes De Fonctionnement/Sécurité page 19

BM 1609B04985 11-14_CM12SD 11/12/14 2:52 PM Page 19
WARNING
source before
adjustment or repair.
Note: Follow instructions when Checking 45 degree
Bevel Adjustment from the left or right side of miter saw.
Checking 45° Bevel Adjustment
1. Lower head assembly and engage head assembly
lock pin.
2. Rotate table to 0° miter position and lock.
3. Slide the head assembly completely to the back
and engage the slide rail lock knob by tightening
the knob to the right (clockwise).
4. Remove the sliding fences completely to avoid
hitting it with the saw head.
5. Pull bevel lock lever forward to unlock the head
assembly.
6. Check range of Bevel Range Selector Stop. It
should be at 45°, (figure 18).
7. Tilt the saw assembly to the left or right until you
feel it stop. This is where the saw is currently set
for 45° bevel cut.
Note: To bevel the saw to the right, the zero bevel
detent must be pulled forward.
8. Use a combination square to check blade
squareness to the table. Place the combination
square on the table and press its 45° surface
against the blade. If the blade does not contact the
full length of the square, follow the calibration
procedure. (see figure 19)
Calibrating Blade at 45° Bevel
Note: Use a 10mm wrench for adjustment.
Note: Calibrating the bevel setting automatically
calibrates the 33.9°, 22.5°, and 45° left or right stops.
1. Lower head assembly and engage head assembly
lock pin.
2. Slide the head assembly completely to the back
and engage the slide rail lock knob by tightening
the knob to the right (clockwise).
3. Remove the sliding fences completely to avoid
hitting it with the saw head.
4. Check bevel range selector stop located on the
left and right side of the bevel post on the table. It
should be at 45°.
5. Pull the bevel lock lever forward to unlock the head
assembly.
6. Locate the bevel stop bolt along the left or right
Adjustments
45° Bevel Stop
To avoid possible
disconnect plug from power
performing any assembly,
injury,
FIG. 18
lock Nut
Bevel
Stop Bolt
Bevel Range
Selector Stop
side of the bevel post. This bolt features a lock nut.
(figure 18)
7. Loosen the bevel stop bolt a quarter turn and then
loosen the lock nut. When this is complete you will
be able to adjust the bevel stop bolt by hand.
A. Rotate the bevel stop bolt clockwise to adjust
the head to the lift.
B. Rotate the bevel stop bolt counter-clockwise
to adjust the head to the right.
8. Follow the procedure in "Checking Left 45° Bevel
Adjustment" to check your modifications. If further
adjustment is required, repeat the steps above.
9. Once satisfactory, lock the bevel lock lever at 45°
to prevent movement.
10. Finger tighten the lock nut in place. Once
secured, tighten with wrench.
19.
FIG. 19