Bosch CM12SD Consignes De Fonctionnement/Sécurité page 22

BM 1609B04985 11-14_CM12SD 11/12/14 2:52 PM Page 22
Switch Activation
For safety, the switch lever is designed to prevent
accidental starts. To operate safety switch, slide the
switch "Lock-OFF" release button with either thumb to
disengage the lock, then pull the power switch trigger
and release the switch "Lock-OFF" release button
(figure 24). When the power switch trigger is
released, the switch "Lock-OFF" release button will
engage the power switch trigger automatically, and
the lever will no longer operate until either "Lock-Off"
release button is engaged again.
NOTE: Power switch trigger can accommodate a
padlock with a long shackle of up to 5/16" in diameter
(not provided with miter saw) to prevent unauthorized
use.
This saw is equipped with a Chop/Crown Lock
feature that is intended to lock the head assembly in
place while giving the maximum capacity for upright
cuts and crown cuts.
Engaging head for Chopcuts
and Crown Molding
1. To engage the Chop/Crown feature ensure that the
slide rail lock knob is unlocked.
2. Slide the head assembly forward and rotate the
chop/crown lock into position, see figure 25.
The saw is capable of making upright cuts against
the fence up to 6-3/4" tall when this function is used.
preparing for Saw Operations
Chop/Crown lock
Switch "lock-Off"
FIG. 24
Release Button
padlock
Hole
FIG. 25
Slide Rail
lock Knob
22.
power
Switch
Trigger
Chop/Crown
lock