Bosch CM12SD Consignes De Fonctionnement/Sécurité page 13

BM 1609B04985 11-14_CM12SD 11/12/14 2:52 PM Page 13
WARNING
source before
adjustments or repairs.
Attaching the Dust Bag
To attach the dust bag, squeeze the two red tabs
together and slide the dust bag into the dust port rib
(see figure 4).
Using and Cleaning the Dust Bag
Using Dust Bag – Attach the clean bag to the dust
port.
Cleaning Dust Bag – After the dust bag is 2/3 to 3/4
full, remove it from the saw. Bring the bag to a proper
container and pull open the zipper located on the
bottom of the bag. Hold the bag by the coupler end
and shake it vigorously until all the dust and debris
fall from it. Close zipper and reattach the bag.
NOTE: Clean the bag at the end of the cutting
session and before transporting or storing the saw.
WARNING
fine particle form may be explosive. Do not throw
sawdust on
combustion, in time, may result from the mixture
of oil or water with dust particles.
Attaching a Vacuum Cleaner
The dust chute has an exit port which will accept a
standard 35mm diameter vacuum fitting or a 1-1/4"
tube diameter. The 35mm diameter fitting is the
standard size used on the Bosch Vacuum Cleaners.
For larger vacuum tube sizes, use an adaptor.
Attaching to Vacuum – Insert the vacuum fitting or
tube into the exit port as far as it will go, (figure 5).
Check to see that the vacuum hose is free from the
mechanism and cutting path before plugging saw into
power source.
Rubber Deflector
When slide cutting extra-tall materials (3-1/2" high),
the rubber deflector (figure 6) will contact and flex
over these materials. It will also contact and flex
when the saw is pulled back before the cut. It will
return to its original shape after the cut.
Assembly
Assembling Dust Collection System
To avoid possible
disconnect plug from power
performing any assembly,
Be extremely careful
disposing of dust. Materials in
an open fire. Spontaneous
injury,
FIG. 4
Dust Bag
Vacuum
Hoses
when
1-1/4 inch
Diameter
FIG. 6
13.
Red Tabs
Dust Port
35 mm
Diameter
FIG. 5
Dust Port
Rubber
Deflector