Recline Adjustment
1
- Squeeze the recline adjustment button to adjust the enhanced child
restraint to the proper position. (19)
2
- Both rear facing mode and forward facing mode have 5 recline positions,
the recline angles are shown as. (20)
Rearward Facing Mode
(Child height 40cm-105cm/ Child weight ≤18kg)
Please install the enhanced child restraint on the rear vehicle seat, and then
place the child in the enhanced child restraint.
1
- Push the enhanced child restraint down onto the base (21). If the enhanced
child restraint is secure, the enhanced child restraint indicator will show
green. (22)
2
- To release the enhanced child restraint, first take the child out of the child
restraint. Squeeze the child restraint release button (23)-1, then lift the child
restraint up (23)-2.
The enhanced child restraint can ONLY be installed and released when in
rearward facing mode.
3
- Press and hold the ISOFIX adjustment button and push the enhanced child
restraint system back until it comes in contact with the vehicle seatback.
(24)
4
- Press and hold the rotation button to rotate for easier side loading/
unloading of the child, then rotate the seat to the rear facing position. (25)
Press the rotation button on either side to rotate the enhanced child
restraint.
5
- Press the harness adjustment button while pulling the shoulder harnesses
to the desired length (Pull from below the fixed shoulder pads to lengthen).
(26)
6
- Unlock the buckle of the harnesses by pressing the red button. (27)
7
- Place the buckle tongues against the magnetic area on the outer side of the
enhanced child restraint so that the tongues are held in place. (28)
11
TODL next instruction
Use Infant Insert
We recommend using the full infant insert while
We recommend using the full infant insert while the
the baby is under 60cm and ≤13kg. It can be
baby is under 60cm and ≤13kg. It can be used until
used until they outgrow the insert.
they outgrow the insert.
The infant insert increases side impact
The infant insert increases side impact protection.
protection.
8
- Place the child into the enhanced child restraint and pass both arms
through the harnesses.
9
- Engage the buckle. Please refer to (29).
10
- Rotate the enhanced child restraint to rearward facing. The enhanced child
restraint indicator will show green. (30)
11
- Pull down the adjustment webbing and adjust it to the proper length to
make sure your child is properly secured. (31)
Always keep child secured in harness and properly tightened by removing
any slack.
TODL next instruction
12