Nolangroup N-Com X Serie Mode D'emploi page 61

N.B.: The pairing is stored by both the helmet and the navigator hence it is not lost when they are
switched off. This means that this procedure needs to be carried out only once. Once the Bluetooth
device has been paired, connection is automatic when the system is turned on.
NB: if the B602 system's memory has already stored a navigator, the new pairing will overwrite the
previously paired navigator.
N.B.: Intercom connection is automatically cut off every time the navigator gives directions and
restored at the end of the message from the navigator.
14. INTERCOM RIDER-PASSENGER
The N-Com B602 system allows intercom connection via Bluetooth with another N-Com system. In
order for the two N-Com systems to communicate, they must first be paired.
14.1. N-Com "600"/"800"/"900" Series Intercom pairing
Important: The procedure described below refers exclusively to pairing with "600"/"800"/"900" series
N-Com systems.
Make sure the systems are turned off.
•
Put the systems in "Pairing" mode: press and hold the "n" key for 4 seconds, until the red LED
•
light appears.
On both the B602 in Complete Mode and the "900"/"800"
•
hear the voice prompt "
With B602 systems in Simple Mode
On one of the two systems, briefly press the "n" key.
•
After a few seconds the systems recognize each other and intercom communication is
•
established.
Through the N-Com EASYSET APP, the "
mode allows the N-Com systems to be recognised and stored through a QR code
generated on your smartphone.
Intercom Easy Pairing
The
14.2. Pairing with other N-Com Systems
"Pairing Other N-Com"
The
Important: The procedure described here below refers exclusively to pairing "600" series N-Com
systems with N-Com systems OTHER THAN the "600"/"800"/"900" series
Make sure the systems are turned off.
•
Put the B602 system in "Pairing" mode: press and hold the "n" key for 4 seconds, until the red LED
•
light appears.
Set the N-Com system (excluding the "600"/"800"/"900" series) to "Pairing": press and hold the
•
"n" key for 4 seconds, until the LED light flashes rapidly.
On the B602 system, hold the "" key until you hear the voice prompt "
•
and then briefly press the "n" key.
1 Except for Bluetooth kit and Bluetooth kit2, which are not compatible.
Intercom Pairing
".
: briefly press the "" key.
function is only available for the N-Com series "600"/"800"/"900".
function is available only in Complete Mode.
systems, press the "" key until you
Intercom Easy Pairing
.
1
" can be carried out. This
Pairing other N-Com
"
25