Nolangroup N-Com X Serie Mode D'emploi page 44

EN
3. INSTALLATION ON THE X-1005, X-903, X-552 HELMET
Important: Prior to installing the N-Com system, it is recommended to write down the identification
code affixed to the product (see chapter 19.4).
The installation video can be seen at www.n-com.it / Support section.
3.1. Preliminary operations
• Remove the internal comfort padding by following the specific instructions provided in the helmet
user manual, being careful to also remove the size adjustment tab.
• Remove from the polystyrene cheek pads the foam material at the housing of the N-Com
earphones. Keep this filling materials should you decide in the future to use the helmet without the
N-Com system installed.
3.2. Installing the system in the X-1005, X-903, X-552 helmets
• On the left side of the helmet, open the cheek pad lining door (Fig. 1). Remove the filling material.
Keep it in case you want to use your helmet without the N-Com system installed in the future.
• Remove the small N-Com cap positioned on the left side of the helmet. To make the operation
easier, we recommend pushing the cap from inside the helmet (Fig. 2).
• Thoroughly clean the outside surface of the shell to make sure that the adhesive keypad sticks
properly. Before you apply the keypad, make sure that the shell area is completely clean and grease
or dirt free.
• Remove the protective film from the back of the adhesive keypad using the special tab (Fig. 3).
• Pass the keypad cable through the hole in the outer shell (Fig. 4).
• Apply the keypad to the shell and press down on its entire surface to make sure that it sticks
properly (Fig. 5).
Fig. 1
Fig. 4
N.B.: Make sure you do not glue the cable underneath the keypad.
8
Fig. 2
Fig. 5
Fig. 3