EINHELL 42.506.90 Instructions D'origine page 24

6.11 Drilling wood
Please note that sawdust must be properly eva-
cuated when working with wood, as it can pose
a health hazard. Ensure that you wear a suitable
dust mask when performing work that generates
dust.
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
The table drill is to a large extent mainte-
nance-free. Keep the device clean. Pull out
the mains plug before doing any cleaning and
maintenance work on the machine. Do not
use any harsh, abrasive cleaning solvents.
Ensure that no liquid seeps into the device.
Regrease all bare parts when the work is
finished. The drill pillar, blank parts of the
column, and the drill table especially should
be regreased at regular intervals. Use a stan-
dard, acid-free lubricating grease to do this.
Caution: Do not use your household refuse
bin as a receptacle for oil and grease-soaked
cleaning rags or grease and oil sludge. Dispo-
se of these toxic materials in an environmen-
tally-friendly fashion. Regularly check and
clean the ventilation holes. Store the device
in a dry room. Should the device become
damaged, do not try to repair it yourself; leave
this work to the hands of a qualified electrical
technician.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
Anl_TE_BD_550_E_SPK9.indb 24 Anl_TE_BD_550_E_SPK9.indb 24
GB
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.2.1 Changing the V-belt (Figs. 20-22)
The V-belt of the pillar drill is a wear part and
should be replaced when worn. Proceed as fol-
lows:
•
Run the machine run in idle mode while slow-
ly setting the speed adjustor lever (15) to the
minimum speed.
•
Switch the machine off, then pull the power
plug.
•
Set the speed adjustor lever to the maximum
speed setting to slacken the V-belt.
•
Move the fastening rail (23) to the lowest po-
sition so that the V-belt cover can be comple-
tely opened. To do so, undo the thumb screw
(21) to enable the fastening rail to be pushed
down.
•
Undo the screw (33) to open the V-belt cover
(7).
•
Pry the V-belt (35) off of the drive pulley (34)
by pulling up the belt on one side and slowly
turning the pulley. The drive pulley comprises
two disks that are pressed together via a
spring. If the V-belt does not exhibit enough
play to remove it, gently press the bottom half
of the drive pulley down to slacken the V-belt.
•
Fit one end of the new V-belt to the variable
pulley (36). Fit the other end to the drive
pulley by first sliding it into the groove on
one side of the pulley, then prying the V-belt
across the pulley into the groove on the other
side.
•
Close the V-belt cover and screw down using
the screw.
- 24 -
16.06.2020 12:46:39 16.06.2020 12:46:39