Publicité
Les langues disponibles
Les langues disponibles
Assembly
STEP 2 Fasten the Rail to the Motor Unit
To avoid SERIOUS damage to garage door opener, use ONLY those bolts/fasteners mounted
in the top of the opener.
1.
Insert a 1/4"-20 x 1-3/4" bolt into the cover protection bolt hole on the back end of the rail
as shown.
Tighten securely with a 1/4"-20 lock nut. DO NOT overtighten.
2.
Remove the bolts from the top of the motor unit.
3.
Use the carton to support the front end of the rail.
4.
Place the "U" bracket, flat side down onto the motor unit and align the bracket holes with
the bolt holes.
5.
Fasten the "U" bracket with the previously removed bolts; DO NOT use any power tools.
The use of power tools may permanently damage the garage door opener.
"U" Bracket
Bolt
Cover Protection
Bolt Hole
Lock Nut
8
HARDWARE
Bolt
1/4"-20x1-3/4"
Bolts (Mounted in the
garage door opener)
Lock Nut
1/4"-20
Publicité
