Publicité
Les langues disponibles
Les langues disponibles
BM 2610032211 09-13_BM 2610032211 09-13.qxp 9/26/13 8:55 AM Page 11
When the trigger switch is released it
activates the brake to stop the chuck quickly.
This is especially useful in the repetitive
driving and removal of screws.
BUILT IN WORK LIGHT
Your tool is also equipped with a light that turns
on automatically when the switch is activated,
for better visibility when drilling/driving (Fig. 1).
DRILL/HAMMER DRILL SELECTOR RING
(Model HDS182 only)
The selector ring allows the tool to be set for
various drilling/hammer drilling applications.
Rotate the selector dial right or left
depending on the below applications (Fig. 9).
Drill only action: For drilling in woods, metals,
plastics or other non concrete materials.
Set Forward/Reversing lever to the center (off
position). Slide charged battery pack into the
housing until the battery pack locks into
position (Fig. 10).
Your tool is equipped with a secondary locking
latch to prevent the battery pack from
completely falling out of the handle, should it
become loose due to vibration.
FIG. 10
B TTERY P CK
You will extend the life of your bits and do
neater work if you always put the bit in
contact with the work before pulling the
trigger. During the operation, hold the tool
firmly and exert light, steady pressure. Too
much pressure at low speed will stall the tool.
Too little pressure will keep the bit from
BRAKE
INSERTING AND RELEASING BATTERy PACK
Operating Tips
Drill with hammer action: For drilling in
concrete, asphalt, tile or other similar hard
materials. The hammer drill position overrides
the clutch for hammer drilling.
MODE
SELECTOR
RING
To remove the battery pack, press the battery
pack release button and slide the battery pack
forward (Fig. 11).
Press the battery pack release button again
and slide the battery pack completely out of
tool housing (Fig. 11).
B TTERY P CK
RELE SE BUTTON
1
cutting and cause excess friction by sliding
over the surface. This can be damaging to
both tool and bit.
DRILLING WITH VARIABLE SPEED
The trigger controlled variable speed feature
will eliminate the need for center punches in
-11-
FIG. 9
FIG. 11
2
Publicité
