Nicols MYLED 64 FC Notice D'utilisation page 14

NOTES :

Display board will be blackout if there is no operation for 20 seconds. Press any button to have it back on.

Press the UNLINK button 3 sec, the fixture will disconnect from the current wireless DMX links, then you can connect
to new link

To restore the factory settings without IR remote : turn off the device. Press MODE+SETUP and turn it on

To have a look at the temperature of the device, press MODE when turning on the device. If Tr1:Er : shows, turn the
device off and let it cool down.

If a red light is on after the automatic check-up when the device is turned on, turn it off, wait a few minutes and turn it
back on

If a red light is blinking : it's time to charge the device

When under charging state, the red light remains ON. When device is fully charged, the red light is OFF.
All manuals and user guides at all-guides.com