Publicité
Les langues disponibles
Les langues disponibles
DISCONNECT AND CONNECT WITH WIRELESS DMX SIGNAL TRANSMITTER
1.
Press MODE until WIRELESS SETUP is on, then press SETUP
2.
Press UP or DOWN buttons to select ON or OFF
ON : enable to receive wireless DMX signal
OFF : unable to receive wireless DMX signal
All working modes have the wireless DMX function
When the device is working as a host or linked with DMX cable, turn off the wireless DMX to avoid interference
During the setting of the wireless DMX, if the device is disturbed by the wireless DMX signal, it may cause the device to
work abnormally: make the device blackout, then power on, i twill work properly.
IR REMOTE OPERATION
The device can be controlled by IR remote except under working modes MASTER/SLAVE and DMX.
It is used for easy operation. For more operation, please do it by the buttons of the device.
1.
Choose AUTO running mode
Press AUTO on the IR remote
-
To adjust running speed, press SPEED then + or –
-
To adjust flash speed, press STROBE, then + or -. To stop the flash, press STROBE again.
-
2.
Choose BUILT-IN PROGRAMS mode
Press PRG on the IR remote
-
Use + or – to select your program from PR02 to PR18
-
To adjust running speed, press SPEED then + or –
-
To adjust flash speed, press STROBE, then + or -. To stop the flash, press STROBE again
-
3.
Choose SOUND-ACTIVE mode
Press SOUND on the IR remote
-
To adjust sound sensitivity, press on + or –
-
4.
Choose STATIC COLOR DIMMING mode
Press on DIMMING on the IR remote
-
Press on R, then adjust the brightness of RED with + or -
-
Press on DIMMING, then G, then adjust the brightness of GREEN with + or –
-
Press on DIMMING, then B, then adjust the brightness of BLUE with + or –
-
-
5.
Choose STATIC COLOR mode
Press any number from 0 to 9 on the IR remote
-
VALUE
0
1
Cyan
Purple
You can directly select color RED, GREEN, BLUE, AMBER and WHITE by pressing button R / G / B / A / W. This will work if you
didn't press on DIMMING first.
6.
Blackout and restore factory settings
Press on ON/OFF button to switch off the device. Turn it on again, the last operation state is saved.
-
Under the BLACKOUT state, press 9+8+7, then turn it on, it will restore factory settings.
-
After restore factory settings, the wireless DMX will turn on. If no need for this function, please reset it.
-
All manuals and user guides at all-guides.com
2
3
4
Rosiness
Yellow
White
5
6
7
Pink
Light
Baby
Green
Blue
8
9
Fawn
Warm
White
Publicité
