Porter Cable PXCMLC1683066 Manuel D'instructions page 7

Ä
Fill pump to correct mark and check often.
STOP
Use synthetic blend, non-detergent air compressor oil.
1. Unpack the air compressor. Inspect the unit for damage. If the unit has been
damaged in transit, contact the carrier and complete a damage claim. Do
this immediately because there are time limitations to damage claims.
The carton should contain:
• air compressor
• operator/parts manual
• air filter assembly
2. Check the compressor's serial label to ensure that you have received the
model ordered, and that it has the required pressure rating for its intended
use.
3. Attach handle to compressor as shown in Fig 2a.
4. Attach air filter assemblies to pump as shown in Fig. 2b.
5. Locate the compressor according to the following guidelines:
a. Position the compressor near a grounded electrical outlet (see
GROUNDING INSTRUCTIONS. Avoid using an extension cord; use a
longer hose instead.
b. The flywheel side of the compressor must be at least 12 inches (31 cm)
from any wall or obstruction, in a clean, well-ventilated area, to ensure
sufficient air flow and cooling.
c. In cold climates, store portable compressors in a heated building when
not in use. This will reduce problems with lubrication, motor starting and
freezing of water condensation.
d. The compressor must be level to ensure proper lubrication of the pump
and good drainage of the moisture in the tank.
6. Connect an air hose (not included) to the manifold outlet.
ASSEMBLY
Fig. 2a Fig. 2b
7 - ENG