emerio SEW-121820 Mode D'emploi page 9

SEWING
1. Turn the hand wheel counterclockwise to raise the needle to its highest position.
2. Raise the presser foot lifter and place the fabric you want to sew under the presser foot (Fig.11).
3. Lower the presser foot. (Fig.12).
4. Rotate the pattern selection dial to select the stitch pattern you wanted.
Caution:

Before you change the stitch pattern, please turn off the switch and turn the hand wheel to raise the
needle all the way up so it doesn't get stuck and bent.

Changing the stitch pattern is not allowed when the machine is running, otherwise the needle and/or
machine may damage.
5. Turn the hand wheel several times to make sure there is no jamming in the stitches.
6. Slide the power switch to the position "L" (meaning low speed) or "H" (meaning high speed), and the
machine will automatically start sewing. We recommend the low speed for beginners (Fig.13).
7. When you finish the sewing, turn off the switch, unplug the adapter, turn the hand wheel to raise the
needle all the way up, lift the presser foot, and then gently remove the fabric from the sewing machine,
and cut the thread with the thread cutter (Fig.14).
Tips:

Please turn the hand wheel if it is difficult to remove the fabric, and then pull out the fabric gently.

If the thread had tangled or jammed, please turn the hand wheel and simultaneously pull the thread
slightly to release the thread. Bottom bobbin mechanism is a more precise part, inappropriate actions
may damage it. Please to not push or pull it by finger or any tools.
Fig.9
Fig.11
Fig.13
- 8 -
Fig.10
Fig.12
Fig.14