emerio SEW-121820 Mode D'emploi page 5

SEW-121820
PARTS IDENTIFICATION
Front view
1. Take-up lever
2. Upper thread tension dial
3. Pattern selection dial
4. Thread cuter
5. Light
6. Needle clamp screw
7. Bottom bobbin
8. Drawer
9. Hand wheel
10. Reverse button
11. Power & speed switch
Back view
1. Bobbin winder pin
2. Bobbin winder stop
3. Foot pedal input
4. Bobbin winder tension disk
5. Presser foot lifter
6. Presser foot
7. DC input
8. Battery compartment
9. Spindle
USING THE FOOT PEDAL (A) AND ADAPTOR (B)
1. Connect the foot pedal by inserting the jack into the foot pedal input socket. Then you can use the foot
pedal to turn on the machine instead of using the hand switch (Power & speed switch).
2. Connect the adaptor's jack to the DC input socket on the back of the machine, and connect the plug to the
main power supply.
Caution:

Make sure the foot pedal is unplugged from the machine when you are
not using it, so the sewing machine won't accidentally start up.

The foot pedal cannot be used together with the power & speed switch.
Make sure the switch is placed at the position "OFF".

There is no speed selection when using foot pedal to control the
machine.
INSTALLING THE BATTERIES
1. Make sure the "Power & speed switch" is on the position "OFF".
2. Turn the sewing machine over on a flat surface and remove the battery compartment cover.
3. Insert 4xAA batteries into the compartment and replace the battery cover.
Caution:

To prevent the accidental start-up of the sewing machine, always make sure that the "Power & speed
- 4 -
EN