Publicité
USE
2 • Filling the water tank
IMPORT NT Before filling the water tank, unplug the iron and set the steam control to dry
position
.
Tilt the iron. Open the filling inlet (fig.6). Pour in water up to the max mark (fig.7).
Close the filling inlet (fig.8) and return the iron to the horizontal.
3 • Temperature and steam adjustment
Set the iron temperature to suit the type of material using the temperature control
dial (fig.3).
Temperature control*: The temperature control light indicates that the soleplate is
heating up. When the temperature control light goes off (fig.10), the set
temperature is reached and you can begin ironing.
Ironing label
IMPORT NT The iron takes longer to cool down than to heat up. We recommend that you start
with fabrics to be ironed at a low temperature.
For mixed fabrics set the temperature for the most delicate fabric.
TIP lways spray starch onto the reverse side of the fabric to be ironed.
4 • Dry ironing
Set the variable steam control to
of material (care points •, ••, •••).
5 • Steam ironing
You can steam iron from temperature setting •• upwards.
Steam function* :
steam quantity) and maximum steam quantity
We recommend setting to maximum steam quantity only when the iron is at
temperature setting •••.
6 • Shot of steam
(from temperature setting •• upwards)
Press the shot of steam button
Wait a few seconds between each shot before pressing the button again.
7 • Vertical shot of steam
(from temperature setting •• upwards)
TIP Hold the iron 10 to 20 centimetres away from the garment to avoid burning delicate fabrics.
Hold the iron to the vertical and press the shot of steam button
creases from suits, jackets, skirts, hanging curtains etc.
Wait a few seconds between each shot before pressing the button again.
IMPORT NT Never direct the steam at persons or animals!
8 • Spray
Press the spray button
9 • Anti-Drip system*
This prevents water escaping from the soleplate when the temperature is too low.
10 • Automatic electronic 3-position cut-off*
If, although switched on, the appliance is not moved, it will automatically switch off
and the auto off light will blink after the following intervals:
- After 30 sec., if the iron is left resting on the the soleplate or lying on its side.
- After 8 mins., if the iron is left resting on its heel.
To switch the iron back on, move the iron gently.
(*) Depending on model
Fabric
Synthetic fibres, e.g.
viscose, polyester...
Silk, wool
Cotton, linen
(fig.11) and set the temperature to suit the type
The steam quantity can be set to between no steam
to generate a powerful jet of steam (fig.14).
to dampen stubborn creases (fig.16).
Temperature
(fig.12).
3
control
•
••
•••
(minimum
( fig.15) to remove
EN
Publicité
