Razor Crazy Cart XL Mode D'emploi page 81

Your Crazy Cart XL has been shipped with the Drift Bar in the unlocked position (without the Drift Bar Lock Knob installed) allowing for full use
of the Drift Bar functions. Use of the Drift Bar is recommended for experienced riders allowing ultimate drift control. It is recommended that you
follow the directions below for "Driving with Drift Bar Locked" while you get comfortable with the unique riding and drifting capabilities of the
Crazy Cart XL.
Note: Lock Knob removal and installation procedures should be made without a rider sitting in the product and with the power turned off.
Driving with Drift Bar Unlocked
Removing the Drift Bar Lock Knob frees up the Drift Bar to give drivers dynamic control over the angle of the caster wheels, which allows driving
that is otherwise impossible. Drivers can control the angle of the caster wheels by moving the Drift Bar back and forth.
In order to unlock your Drift Bar and allow drivers to dynamically control the degree of incline on the rear casters, simply remove the Lock Knob.
Removing the Lock Knob
Lock Knob
1 Remove the Lock Knob by turning it
counterclockwise. Keep the Lock Knob for
future use.
Driving with Drift Bar Locked
Great for beginners and for racing friends. Locking the Drift Bar simplifies the controls and allows drivers to keep both hands on the steering
wheel without having to worry about the Drift Bar popping up if you turn too hard.
In order to lock your Drift Bar, simply install the Lock Knob.
Installing the Lock Knob
1 Pull the Drift Bar up so that the hole on the
Drift Bar lines up with the threaded hole on
the baseplate.
2 Insert Lock Knob through Drift Bar and into
the threaded hole on the baseplate (Note:
Holding the Drift Bar up while threading in
the Lock Knob will make it easier to thread
the Lock Knob into place).
79
Original instructions
3 Turn the Lock Knob clockwise as far as you
can to secure it in place. Do not overtighten.