Hurst Jaws Of Life E+Draulic E3 Connect Mode D'emploi page 10

4.6.7. LIFTING
Actuate the star grip in the opening direction (figure H). When lifting vehicles or oth-
er moving loads, make sure that the load is prevented from sliding away and that
the spreader tips are placed far enough under the load to prevent slipping�
Constantly monitor and support the load when lifting�
en
4.7. REPLACING THE TIPS (SC AND SP ONLY)
The removable tips are connected to the device arm with bolts� To remove the tips, the
bolts must be fully pushed in and then fully locked again (page 2; figure I; numbers 5+6)
4.8. ATTACH THE EXTENSIONS (R 320 AND CR 522)
The rescue rams can be adapted to the respective operating situation by attaching
various extensions� To do this, the rear claw can be removed without tools and the
suitable extension attached (Figure Q)� Make sure that the replaceable parts are
always fully inserted�
4.9. AUTOMATIC SWITCH-OFF
If the rescue device is not activated for a period of 60 minutes, it switches off auto-
es
matically�
4.10. DISMANTLING/SHUTTING DOWN AFTER OPERATION
Once work has been completed, the device arms should be closed until the tips are
only a few millimeters apart and the ram piston should be fully retracted and then ex-
tended a few millimeters� This relieves hydraulic and mechanical strain on the device�
For transport and storage, all devices should be secured and not loosely stored�
5. DISPLAY AND CONTROL PANEL
5.1. MAIN SWITCH (FIGURE M; NO. 1)
fr
For cutting and combination devices, the main switch includes the indicator for the
cutting angle monitoring� (Figure F�) If the device twists to the right or left by an
angle critical for the blade stability during the cutting process, the blue ring changes
color to red� Attention! Check whether you can complete the cutting process with-
out danger or whether you must reposition on the object to be cut�
5.2. BATTERY INDICATOR (FIGURE M; NO. 2)
The battery indicator indicates the current battery capacity� In WiFi mode, the bat-
tery indicator indicates the signal power�
5.3. LOAD INDICATOR (FIGURE M; NO. 3)
The load indicator scale indicates the tool's pressure range while working, and
pt
provides information about the remaining capacity� The load indicator also indicates
whether the device is sending or receiving data via WiFi�
5.4. CONTROL LIGHT FOR THE TURBO FUNCTION (FIGURE M; NO. 4)
The star grip can be moved by 20° in any direction; with a move starting at 15°,
the turbo function is activated, the device moves faster� The turbo function is only
available in the low-pressure range�
10