Télécharger Imprimer la page

EDM Product 33823 Manuel D'instructions page 18

Publicité

Les langues disponibles

Les langues disponibles

WARNINGS
ES
▶Please turn off the main power before installation. The installation
must be carried out by a specialist or qualified personnel.
▶All wiring must be done in accordance with local electrical codes or
the National Electrical Code.
PT
▶Make sure that the distance between the door and the tips of the fan
blades is a minimum of 2.13m. There must always be a minimum
distance of 1m between the blades and any type of wall or object.
▶Do not lift or carry the fan by holding the cables.
EN
▶Installation, use and maintenance of the fan must be done with
caution by installers or users. Responsibility for these factors rests
with the user.
FR
▶Not suitable for sloped ceiling.
REMOTE CONTROL
▶1h - Auto off after 1h.
▶2h - Auto off after 2h.
▶4h - Auto off after 4h.
▶8h - Auto off after 8h.
▶Fan off - wifi pairing.
▶Rotation direction.
▶Light on / Light off.
▶Natural wind (automatic cycle 1-6 speeds)
REMINDERS
▶If the remote control fails to control the fan, first check that the
batteries are inserted correctly and that they are charged.
▶If the remote control fails to control the fan, you can use the code
recovery mode to re-bind the emitter and receiver.
• Turn on the fan and press the remote button
• If you hear a long "bee" sound, it means it has worked.
• It is important to keep in mind that if the action between turning
on the fan and pressing the button exceeds the time of 10
seconds, the synchronization is automatically canceled.
▶Another possibility is if there are other devices also controlled by
remote control that can cause interference.
▶For good maintenance, when you don't use the remote control for a
long time, take out the batteries inside.
▶When you install the fan, the cover that is located on the ceiling
must not press the antenna or any other cable, because it will not
receive the signal from the remote control, because it can be easily
broken and/or cause a short circuit.
Instruction manual
SUMMER: creates a descending airflow, producing a cool breeze.
WINTER: Creates an upward airflow that pushes warm air from the
ceiling and circulates it downwards.
FAN BALANCE
▶Place the clamp in the center of a paddle and turn on the fan. If
▶Once you have located the blade that needs the counterweight, test
for 5 seconds.
▶Stick the counter weight on the blade surface at the correct height.
the rocking persists, insert the clamp into another blade until the
rocking is reduced. When it stops swinging, it will have found the
blade that needed the counterweight.
the best place to place the clamp. From the center to the tip of the
blade, until the rolling disappears.
Remove the clamp and test the fan. If you're still wobbling, add
another counterweight using the same steps. If it gets worse, try
installing the fan in another area.
Ref. 33823

Publicité

loading