Publicité
Les langues disponibles
Les langues disponibles
recoil starter handle slowly until a slight resistance is felt, then pull quickly to start the engine.
Return cord gently into the recoil starter. Never allow the cord to snap back.
4. If engine fails to start, repeat step 3.
Note: After repeated failed attempts to start the engine, please consult the troubleshooting guide
before attempting again. If problems persist, please call customer service.
Note:
on't allow the starter grip to snap back against the engine. Return it gently to prevent damage
D
to the starter.
KIT HIGH ALTITUDE REPLACEMENT FOR EPAIII ENGINES
3000ft to 6000ft or 6000ft to 8000ft of elevation
At high altitude, the standard carburetor air-fuel mixture will be too rich. Performance will decrease
and fuel consumption will increase. A very rich mixture will also foul the spark plug and cause hard
starting. Operation at an altitude that differs from that at which this engine was certified, for extended
periods of time, may increase emissions.
The fuel system on this Engine or Equipment may be influenced by operation at higher altitudes.
Proper operation can be ensured by installing an altitude kit when required. See the table below to
determine when an altitude kit is required. Operating this generator without the proper altitude kit
installed may increase the engine's emissions and decrease fuel economy and performance. Kits may
be obtained from any dealer, and should be installed by a qualified individual.
Equipment *
Equipment with
engines above 80cc
*Engine, Generator Set, Pressure Washer, Walk-Behind Lawnmower, Compressor, Pump, Tiller
etc.
** Elevation above sea level.
This high altitude jet is to be used at elevations above 3000 feet.
At elevations above 8000 feet, the engine/equipment may experience decreased performance,
even with the high altitude kit.
If a carburetor is replaced, the proper high altitude kit jet will need to be installed into the
replacement carburetor.
Altitude kit Replacement
Operation Instruction
1. Take off fixing bolt and fuel cup.
2. Take off main jet.
3. Replace the main jet(altitude kit )with suitable one applying to
altitude height.
4. Replace the seal ring of fuel cup and fixing bolt.
5. Assemble fuel cup, seal ring and fixing bolt in reverse order.
All manuals and user guides at all-guidesbox.com
Fuel
Altitude Range**
Gasoline
3000 – 6000 ft
6000 – 8000 ft
16
Kit Part Number
0 – 3000 ft
Not Required
Altitude kit 1#
Altitude kit 2#
Publicité
