Dell W2600 Manuel Du Propriétaire page 40

Problem
Poor picture quality when using a device
connected to the ANT/Cable (coaxial)
connector
Nothing appears on my TV
All manuals and user guides at all-guides.com
Possible Solution
Ensure TV is selected as the input source in the Input
1
Select menu. See "Input Select Menu" on page 30 for
more information.
Press Menu on the remote control, select Setup, and
2
then select Channel Setup. This resets the channels.
3
Check the aspect ratio settings in the OSD. Press the
Menu button on the remote control and select Size.
For more information on using the OSD, see "Using
the On-Screen Display" on page 29.
Reset the original factory defaults. Press Menu on the
4
remote control, select Setup, and then select Factory
Reset.
Adjust the color temperature. Press Menu on the
5
remote control, select Picture, and then select Color
Temperature.
6
The problem may be with your device, contact your
service provider.
1
Ensure the TV is turned on.
2
Verify that all the cables are properly connected to the
TV, including the power cable.
3
Check to see if there is a blue or amber light on
the lower, right-hand corner of the TV. A blue light
indicates the TV is on. An amber light, means the TV
is in power save mode.
Ensure the proper source is selected in the Input
4
Select menu. See "Input Select Menu" on page 30
for more information.
5
Reconnect any devices that are currently connected
to the TV. If you are using multiple devices, connect
and test one device at a time.
6
Connect another device that you know is working
properly.
Reset the original factory defaults. Press Menu on
7
the remote control, select Setup, and then select
Factory Reset.
Troubleshooting Your TV
39