Closes too quickly—
Decrease spring tension
If the door closes too quickly, decrease the spring tension by
moving the spring end toward the front of the dishwasher.
NOTE: Springs should be in the same notches on left and right
sides.
Door falls open—
Increase spring tension
If the door falls open, increase the spring tension by moving the
spring end toward the back of the dishwasher.
NOTE: Springs should be in the same notches on left and right
sides.
Move dishwasher into
cabinet opening
Insulation
blanket
IMPORTANT:
If wheels were removed, cover the floor when
moving the dishwasher. Slowly move dishwasher completely into
cabinet opening. Do not kink or pinch water line, drain hose,
power supply cord or direct wire between dishwasher and
cabinet. Remove cardboard from under dishwasher.
NOTES:
g_
Itis all right if dishwasher fits tightly into cabinet opening. Do
not remove insulation blanket — the blanket reduces the sound
level.
mg
If using power cord, make sure to route end through hole in
cutout before sliding dishwasher into cabinet opening.
FE}
Align front of dishwasher
with front of cabinet doors
SS
Align front of dishwasher door panel with front of cabinet doors.
You may need to adjust alignment to be even with your cabinets.
|
Check for plumb and
adjust legs if needed
a
Check that leveling legs are firmly against the floor. Close and
latch the door, and place level against the front panel. Check that
dishwasher is centered from front to back in the opening. If
needed, adjust leveling leg until dishwasher is plumb. Repeat for
other side of dishwasher.
Helpful Tip: Push up on front of dishwasher to raise dishwasher
off the ground to adjust front legs. With some installations, it may
be easier to adjust the front leg using the %s6" hex head socket or
adjustable wrench.
Preferred method
Optional method
15