Télécharger Imprimer la page

Whirlpool DU1030XTXQ4 Instructions D'installation page 10

Publicité

Les langues disponibles

Les langues disponibles

Option D, No waste disposer - with air gap
No \ waste 2 disposer _ "with air gap
— Air gap
-
Large silver drain
hoseclamp
Screw-type clamps <>
Waste tee:
Rubber hose
connector
Drain hose
Connect black end of drain hose to
air gap and cut if needed.
NOTE: Do not cut ribbed section.
Attach drain hose to air gap with
large silver drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
lf the drain hose was cut, use a 11%"
to 2" (3.8 to 5.1 cm) screw-type
clamp (not provided).
Use a rubber hose (not provided)
with screw-type clamps (not
provided) to connect from waste tee
to air gap.
10
Prepare Disnwasher
AWARNING
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
AWARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
1 | Attach insulation
'
|
Completed
Install
A
cs
Using the precut slots in the insulation, fasten the insulation over
the molded hooks on the tub. Be sure to fasten the insulation
down on both sides of the tub.
Put dishwasher on its back
Helpful Tip: Place cardboard under dishwasher until installed in
cabinet opening to avoid damaging floor covering. Do not use
door panel as a worktable without first covering with a towel to
avoid scratching the door panel.
Using two or more people, grasp sides of dishwasher door frame
and place dishwasher on its back.

Publicité

loading

Ce manuel est également adapté pour:

Du1055xtvdaDu1030xtxt4