Publicité
2 – GENERAL INFORMATION
2.1 Regulations & Obligations
The product you have acquired complies to :
the European Directive of Low Voltage Electrical Equipment 2014/35/UE
2.2 Liabilities
1 – The installer and the user must observe the safety rules (collective protection, individual protection)
applicable during transport, assembly, use, and discarding of the product or its components.
2 – The liability of the user may be engaged in circumstances that are not marginal. Thus, the user must
scrupulously comply with the recommendations for storage, assembly, use, maintenance, health and safety,
use-by date, etc. supplied by the manufacturer.
Likewise, where the producer be held liable for the non-conformity of the product, the user may also share
the liability, insofar as he has not, from his side, checked this conformity, even if the product in question is
administratively in conformity. The user is also held liable if he himself increases the fault in the product.
The liability of the manufacturer can be reduced or eliminated, taking all the circumstances into consideration,
when the damage is caused jointly by the product, and by the fault of the victim or a person for whom the
victim is responsible
products 85/374/EEC).
3 - The installer or the user's responsability would be engaged if the working conditions of the cold room (put
into service, shutdown) are not respected (Norm NFP 75 401-1 or local regulations).
4 - The staff of the company installing the equipment, and / or staff of the user company in charge of specific
functions, such as maintenance, must be qualified, trained and certified in the case of particularly risky
work, such as work under power (D. Safety at work 89/655/EEC modified 95/63/EEC art.7 / CT art. R
233-2).
5 – The final user must carry out the periodical yearly or twice-yearly checks, or have them carried out, with
keeping of a maintenance register (D. Safety at work - 89/655/EEC modified 95/63/EEC - art. 4b / CT R
233-1-2 and R 233-11-1).
3 - PRODUCT CHARACTERISTICS
«High-Flow valve 2260 for wall mounting»
The walls of a cold room are constantly subject to strains caused by pressure variations, either from inside or
from outside.
It's a heating, mechanically operated valve, with two water tight mobile flaps, one for admission and the other
for exhaust.
There are two references according to the panel thickness:
REFERENCE
2260
2260/320
and to the Norm NF P75-401 (for French installation)
(D. general safety of products 92/59/EEC et D. liability from the fact of faulty
Tubular cross bar
lenght
240 m m
340 m m
Panel thickness
mini
100 m m
221 m m
- 4 -
maxi
220 m m
320 m m
NM2260/K
Publicité
