Publicité
Les langues disponibles
Les langues disponibles
Step 4
Separate six EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below.
å
Be prepared, the parts are greasy.
Fasten six EXTENSION RAILS (1) to the LEFT END (C) and RIGHT END (D). Use eighteen BLACK 5/8" FLAT HEAD
å
SCREWS (25).
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1st hole shown in the diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other holes that lines up with the holes in the ENDS. Turn a SCREW
into these holes.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
2
Push the release lever up and pull the SLIDE from the RAIL.
BLACK 5/8" FLAT HEAD SCREW
(18 used in this step)
Closed end
423526
25
1
1
1
D
www.sauder.com
1
Use these holes.
1
1
1
The CAM SCREW
must be here.
Closed end
st
1
hole
Closed end
C
Page 9
Publicité
