Sauder Hammond Serie Instructions D'installation page 10

Step 5
Separate six EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below.
å
Be prepared, the parts are greasy.
Fasten six EXTENSION RAILS (1) to the LEFT UPRIGHT (E) and RIGHT UPRIGHT (F). Use eighteen BLACK 5/8" FLAT
å
HEAD SCREWS (25).
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1st hole shown in the diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other holes that lines up with the holes in the UPRIGHTS. Turn a
SCREW into these holes.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Repeat this step to fasten one WIDE EXTENSION RAIL (31) to each UPRIGHT (E and F).
å
EXTENSION RAIL/SLIDE SET
2
Push the release lever up and pull the SLIDE from the RAIL.
WIDE EXTENSION RAIL/SLIDE SET
32
Push the release lever in and pull the SLIDE from the RAIL.
1
E
Closed end
1
1
1
Page 10
1
1
Closed end
Closed end
F
Use these holes.
Use these holes.
BLACK 5/8" FLAT HEAD SCREW
(26 used in this step)
Closed end
www.sauder.com
1
1 st hole
Closed end
31
Closed end
31
E
25
31
F
Closed end
423526