Publicité
Les langues disponibles
Les langues disponibles
10.0 Uninstallation & Return
10.1. Removing the Product
Procedure
1.
Power OFF the energy storage system by following instructions in Chapter 7.2 Shutdown
procedure of the System.
2. Disconnect all cables from the product, including all communication cables, PV power
cables, battery power cables, AC cables, and PE cables.
3. Remove the WiFi module.
4. Remove the inverter from the top of the battery.
5. Remove the wall bracket of the battery.
6. Remove the battery.
7.
Remove the wall bracket of the expansion battery if there is any.
8. Remove the expansion battery if there is any
10.2. Packing the Product
If the original packaging is available, put the product inside it and then seal it using adhesive
tape. If the original packaging is not available, put the product inside a suitable cardboard box
and seal it properly.
10.3. Disposing the Product
If the product service life expires, dispose of it according to the local disposal
rules for electrical equipment and electronic component waste.
Dispose of the packaging and replaced parts according to the rules at the
installation site where the device is installed.
Do not dispose the product with normal domestic waste.
© 2023 Maxeon Solar Technologies, Ltd. All rights reserved. | 547143 Revision B - June 2023
Specifications included in this document are subject to change without notice
Li-Ion
61
Publicité
