Publicité
Les langues disponibles
Les langues disponibles
8.0 Set up a new System (Commissioning)
8.1 Connect Reserve to internet
To initiate the commissioning process for the recently installed SunPower Reserve, it is essential
to establish a functional data connection which is also required for ongoing monitoring. The
SunPower Reserve offers two methods of data connection: Ethernet and Wi-Fi.
If you opt for an Ethernet connection, no additional configuration is necessary. However, if you
prefer a Wi-Fi connection, please adhere to the following steps to connect the system to the
homeowner's Wi-Fi network:
1.
On your mobile device, access the Wi-Fi settings and locate the Wi-Fi network associated
with the SunPower Reserve unit. This network is identifiable by the Serial Number of the
unit.
2. Connect to the Reserve unit network using the default password: 12345678.
3. Once connected, launch your mobile browser and enter the IP address of the SunPower
Reserve: 10.10.10.1. This action will display a simple interface enabling the connection of the
Reserve unit to the on-site Wi-Fi network.
4. Tap the ‚scan' option at the bottom of the screen to search for available networks.
5. From the list of displayed networks, select the desired network to which the Reserve unit will
connect, and input the corresponding Wi-Fi password.
6. Once the connection is successfully established, the interface will provide a confirmation
message stating ‚Connected OK.'
By following these instructions, the SunPower Reserve can be effectively connected and
configured for operation.
If SunPower Reserve has for some reason lost its connection to the internet, for example if the
customer changes the Wi-Fi password, the steps above will also allow customers to reset the
internet connection of SunPower Reserve.
© 2023 Maxeon Solar Technologies, Ltd. All rights reserved. | 547143 Revision B - June 2023
Specifications included in this document are subject to change without notice
51
Publicité
