Makita DTD172 Manuel D'instruction page 9

When the application mode is registered:
The tool switches between the registered application
mode and current application mode every time you
press the quick mode-switching button. The front lamps
on both sides will flash once when the application
mode is changed by pressing the quick mode-switching
button.
NOTE: When the lamp status is off, the front lamps
will not flash even when the application mode is
changed by pressing the quick mode-switching
button.
NOTE: Refer to "Registering the application mode"
in "Quick mode-switching function" section for how to
register the application mode.
Quick reference
The following table shows the functions of the quick mode-switching button.
indicates the quick mode-switching button.
Button(s) / Purpose
(When quick mode-switching function
is OFF)
Changing the impact force by the quick
mode-switching button
(When quick mode-switching function
is ON)
Switching to the registered application
mode
Registering the application mode
Erasing the registered application mode
Disabling/resuming the quick
mode-switching button
: The lamp is blinking.
Disabling the quick mode-switching
button
You can also disable the quick mode-switching button.
After disabling, the quick mode-switching button will not
work for changing the impact force and switching the
application mode.
To disable the quick mode-switching button, press and
hold the quick mode-switching button and the but-
ton at the same time until the all lamps on the panel
blink.
To resume the quick mode-switching button, perform
the same procedure as above again.
NOTE: Registering and erasing the application mode
can be performed even if the quick mode-switching
button is disabled. After registering or erasing the
application mode, the quick mode-switching button
will be activated.
Action
Press
Press
Press and hold (each button)
Press and hold (each button)
Press and hold (each button)
9 ENGLISH
How to confirm
The front lamps on the tool flash once.
The front lamps on the tool flash once.
Example: Wood mode is registered
The lamp of desired application mode
blinks.
All impact force grade lamps blink.
All lamps on the panel blink.