Faber CRISTAL Instructions D'installation page 7

CUSTOMIZING YOUR RANGEHOOD
The front strip of the rangehood can be customized with either
factory supplied strips or a front strip made from the same
materials as your cabinets. Black and Brushed Aluminum
front strips are available from your dealer. The front strip is
attached to the glass screen by three recessed screws on
the back side of the strip as indicated in FIGURE 12. For a
custom front strip, a local cabinet shop can make a strip to
match your cabinets. The front strip dimensions are given
in FIGURE 13.
Side View of Rangehood
Glass
Screen
Front
Strip
Three Screws
FIGURE 12
•
30" or 36"
FIGURE 13
WARRANTY & SERVICE
This rangehood carries a limited warranty against manufac-
turer's defects. To obtain warranty service, contact the dealer
from whom you purchased the rangehood, or the local Faber
distributor. If you cannot identify a local Faber distributor,
contact Faber USA at (508) 358-5353 for the name of a
distributor in your area.
WIRING DIAGRAM
• This rangehood uses Flourescent Lamp Type F33-15W-T8
and Starter Type S2.
Rangehood Control Panel
All controls are located on the right rear side of the
rangehood.
Light On/Off Switch ( L )
Control A is the On/Off switch for the fluorescent light. Moving
the switch to the 1 Position turns the light On. Moving the
switch to the 0 Position turns the light Off.
Blower On/Off Switch ( M )
Control B is the On/Off switch for the blower.
switch to the 1 Position turns the blower On. Moving the
switch to the 0 Position turns the blower Off.
Blower Speed Switch ( S )
Control C is the speed control switch for the blower. Moving the
switch to the 1 Position turns the blower on LOW. Moving the
switch to the 2 Position turns the blower on MEDIUM. Moving
the switch to the 3 Position turns the blower on HIGH.
•
1 15/32"
•
• Operation Indicator Light ( I )
•
Red light will be on when the rangehood is operating.
3/4"
Microswitches
This rangehood is equipped with two microswitches on the
glass screen, one for the light and one for the blower. When
the glass screen is pushed closed, the first microswitch will
turn the blower off. When the screen is closed completely, the
light will be turned off. The next time the screen is opened,
the rangehood will operate at the last settings.
For Best Results
Start the rangehood before cooking and allow the unit to
operate for several minutes after cooking is complete to clear
all smoke and odors from the kitchen.
Cleaning
The metal grease filters should be cleaned frequently in hot
detergent solution or placed in the dishwasher. Clean exterior
surfaces with hot soapy water. Using abrasives and scouring
agents can scratch stainless steel finishes and should not be
used to clean finished surfaces.
Replacing the Fluorescent Light
To replace the fluorescent light, remove the four screws
indicated in FIGURE 15. Remove the light diffuser cover. Be
careful as the diffuser cover is not attached to the light box.
USE AND CARE INFORMATION
FIGURE 14
FIGURE 15
Version 11/98 - Page 7
Moving the