Publicité
Les langues disponibles
Les langues disponibles
2.
Adjust the panel to achieve the required spacing, or to align.
IMPORTANT:
If adjustments are needed, adjust the panel not
the door. Adjust left to right in the mounting bracket before
using the pins to adjust the panel up and down or at an angle.
m_
Slide the panel from side to side in the keyhole slot.
m
Use a
hex key to raise or lower the adjustment pins which
allows the door panel to swivel.
A. Door panel
C. Adjustment pins
B. Panel top bracket
3.
Predrill 4s" pilot holes in the door panel(s) through the open
holes in both the bottom and top hinges.
Using the slotted hex head screws (provided with refrigerator),
attach the top and bottom hinges to the door panels. Fully
tighten all door panel screws.
NOTE: For 36" models, there is an additional bracket at the
top to fasten the panel to the door. Insert the screws through
the bracket into the door panel.
4.
A
\F
V
V
A
D
E
26
A. Top hinge
B. Panel top bracket
C. Holes for screws
D. Door adjustment pins
E. Holes for screws
(36" Models only)
Using slotted hex head screws (provided with refrigerator) for
each side, attach the door panels to the hinge-side door trims.
Using Phillips head flat screws (provided with refrigerator),
install the handle side door trim.
Completely tighten the screws attaching the mounting
brackets, located at the bottom of the doors, to the panels.
Reinstall the top door trim and hinge cover.
Snap the adjustment pin cover (provided with refrigerator) into
place.
10. If necessary, adjust the drawer panel to align and fully tighten
all drawer panel screws.
A. Drawer overlay panel
B. Drawer panel bracket
go Leads,
aig Only)
IMPORTANT:
Install the handles after the door panels have been
installed. Follow the instructions specific to your door panel
design.
Tools Needed: %2" Hex key
Door Panels - Custom Wood, Stainless Steel and
Oiled Bronze Designs
Locate the holes in the door panels where the handle
mounting studs are to be installed.
Fasten the handle mounting studs to the door panels.
Install the handles to the handle mounting studs and tighten
the setscrews.
Door Panels - Floating Glass Design
IMPORTANT: To align the handle correctly on the door, the plastic
handle spacer and the setscrews on the door handle must be in
the positions designated in the chart.
1.
Locate the holes in the door panels where the handle
mounting studs are to be installed.
Insert the circular post on the back of the handle spacers into
the holes in the door panels.
2.
C
s
fF 4
A
v4,
A
\
\
A. Plastic handle spacer
B. Straight handle mounting posts
C. Curved handle mounting posts
D. Circular post
Publicité
