install Refrigerator and Panels
IMPORTANT: Jenn-Air is not responsible for the removal or
addition of molding or wood overlay panels that would not allow
access to the refrigerator for service.
Install Top Grille Filler (standard installation only)
IMPORTANT: The grille panel height allows the necessary airflow
for refrigerator performance. The top grille filler hides the upper
compartment cover behind the top grille. If you choose to modify
the recommended grille panel dimensions, performance will be
compromised.
Custom Wood Panel Models
1.
In the custom made (1" x width of grille panel) wood filler
piece, drill a hole '16" from each edge.
NOTE: Make sure the hole is centered in the 1" thickness of
the wood piece.
2.
Using slotted hex head screws (provided with refrigerator),
fasten an "L" bracket to each end of the wood filler piece.
3.
Using hex head blunt screws (provided with refrigerator),
attach the "L" brackets to the top grille mounting plates.
4.
Adjust the "L" brackets, so that the wood filler piece is flush
with the bottom of the soffit. Completely tighten the screws.
A. Custom weocd filler
B. "L" bracket
C. Grille mounting plate
Side View
D. Grille panel
E. Door panel
A. Top grille filler
B. Soffit
C. Airflow
22
Panel Kit Models
AWARNING
Excessive Weight Hazard
Use two or more people to move and install panels.
Failure to do so can result in back or other injury.
AWARNING
y
a
wa
Broken Glass Hazard
Do not hit refrigerator glass doors.
Protect glass surface and edges during installation or
removal of doors.
Failure to do so can result in serious eye injury or
minor cuts.
1.
Align top grille vent (provided in the door kit) with the bottom
edge of the soffit. Use as a template, and mark where to drill
the holes.
2.
Using slotted hex head screws (provided with refrigerator),
attach the top grille vent to the soffit.
ra
f t
Lik
SI
/
A. Top grille vent
B. Slotted hex head screw
Side View
eh
CO
leoweomees f)
|
C. Grille panel
D. Door panel
A. Soffit
B. Airflow