Thermos Heatwave Rotisserie 07101378 Manuel Du Produit page 5

LP Cylinder Exchange
• Many retailers that sell Heatwave Rotisserie's
option of replacing your empty LP cylinder through an
exchange service. Use only those reputable exchange
companies that inspect, precision fill, test and certify their
cylinders. Exchange your cylinder only for an OPD safety
feature-equipped cylinder as described in the "LP
Cylinder" section of this manual.
• Always keep new and exchanged LP cylinders in upright
position during use, transit or storage.
• Leak test new and exchanged LP cylinders BEFORE
connecting to grill.
LP Cylinder Leak Test
For your safety
• Leak test must be repeated each time LP cylinder is exchanged
or refilled.
• Do not smoke during leak test.
• Do not use an open flame to check for gas leaks.
• Appliance must be leak tested outdoors in a well-ventilated
area, away from ignition sources such as gas fired or electrical
appliances. During leak test, keep appliance away from open
flames or sparks.
• Use a clean paintbrush and a 50/50 mild soap and water
solution. Brush soapy solution onto areas indicated by arrows
in figure below.
• Do not use household cleaning agents. Damage to gas train
components can result.
WARNING
If "growing" bubbles appear do not use or move the LP
cylinder. Contact an LP gas supplier or your fire
department!
All manuals and user guides at all-guides.com
Connecting Regulator to the LP Cylinder
offer you the 1. LP cylinder must be properly secured onto
2. Turn all control knobs to the OFF position.
3. Turn LP cylinder OFF by turning hand-wheel clockwise to a
4. Remove the protective cap from LP cylinder valve. Always use
Safety Relief Valve
5. Hold regulator and insert nipple into LP
Nipple has to be centered
into the LP cylinder valve.
assembly section.)
full stop.
cap and strap supplied with valve.
Strap and Cap
Do not use a POL transport plug
(plastic part with external threads)!
It will defeat the safety feature of
the valve.
cylinder valve. Hand-tighten the
coupling nut, holding regulator in a
straight line with LP cylinder valve so
as not to cross-thread the connection.
appliance . (Refer to
OPD Hand Wheel
Type 1 outlet with
thread on outside
07101378 • 5