Bosch GTC600C Consignes D'utilisation/De Sécurité page 21

• If you want you delete all images, press
the Measuring Functions Button 9 but-
ton or the Right-Hand Function Button
10; you can also confirm the process by
pressing the Right-Hand Function Button
10 or cancel the deletion by pressing
the Left-Hand Function Button 17.
Data fragments of the images remain stored
in the memory and could be reconstructed.
You can select <Tool> -> <Factory settings>
in the main menu to permanently delete.
Data Transfer
Data Transfer via USB Port
(Fig. 1)
Open the Flap for the USB Port 6. Connect
the USB Type-C® Port 7 of the measuring
tool to your computer via the USB Type-C®
Cable 26 provided.
Now press the On/Off Button 12 to switch
on the measuring tool.
Open the file browser on your computer and
select the GTC 600 C drive. The saved files
can be copied from the internal memory of
the measuring tool, moved to your computer
or deleted.
As soon as you have finished the required
operation, disconnect the drive from the
computer following the standard procedure
and then use the On/Off Button 12 to switch
the measuring tool off again.
Always
drive from your operating
system first (eject drive), as failure to do
so may damage the internal memory of the
measuring tool.
Remove the USB Type-C® Cable 26 during
the measuring operation and close the Flap
for the USB Port 6.
Always keep the Flap for the USB Port 6
closed so that dust and splashes cannot en-
ter the housing.
Note: Use USB to connect the measuring
tool to a computer only. The measuring tool
may be damaged if connected to other de-
vices.
Note: The USB Type-C® interface can only
be used for data transfer. It is not suitable
for charging non-rechargeable and recharge-
able batteries.
Functions
disconnect the
-21-
Post-Editing the Thermal Images
You can post-edit the saved thermal images
at:
www.bosch-professional.com/thermal
Data Transmission via WLAN
The measuring tool is equipped with a
Wi-Fi® interface which enables the saved
images taken by your measuring tool to be
wirelessly transmitted to a mobile device.
Special Bosch applications (apps) are avail-
able for this use. They can be downloaded in
the store corresponding to your device:
In addition to the wireless data transfer of
your images, the Bosch applications make it
possible for you to use an extended range
of functions and make it easier to post-edit
and forward measured data (e.g. via e-mail).
Information about system requirements for
a Wi-Fi® connection can be found on the
Bosch website at:
www.bosch-professional.com/thermal
To activate or deactivate the Wi-Fi® connec-
tion on the measuring tool, call up the main
menu, use the buttons to select <WiFi> and
activate or deactivate it. The Wi-Fi® Switched
On/Off Indicator 33 appears in the display
when the Wi-Fi® is activated. Ensure that the
Wi-Fi® interface is activated on your mobile
device. The connection between the mobile
device and the measuring tool can be estab-
lished after the Bosch application has been
started (if the Wi-Fi® modules are activated).
To do this, follow the instructions in the ap-
plication (app).