Publicité
Les langues disponibles
Les langues disponibles
Power Supply
The tool can be operated using a Bosch Li-
ion rechargeable battery.
Operation with Battery Pack
(Fig. 3)
Use only Bosch recharge-
able lithium-ion battery
packs listed in the specifications section of
this manual. Use of other battery packs may
increase the risk of fire, personal injury and
property damage.
Remove
from the tool when not
using it for extended periods. When storing
for extended periods, the batteries can cor-
rode and self-discharge.
Note: The battery pack is supplied partially
charged. To ensure full capacity of the bat-
tery pack, completely charge the battery
pack in the battery charger before using for
the first time.
Use only Bosch chargers
listed in the specifica-
tions section of this manual. Use of other
chargers may increase the risk of fire, per-
sonal injury and property damage.
The lithium-ion battery pack can be charged
at any time without reducing its service life.
Interrupting the charging procedure does
not damage the battery pack.
The lithium-ion battery is protected against
deep discharge by the Electronic Cell Protec-
tion (ECP). A protective circuit switches the
laser level off when the battery is drained.
• Following the automatic shut off of the
tool, do not continue to press the On/
Off button. The battery can be dam-
aged.
To insert the charged Battery Pack 22, slide
it into the Battery Port 43 until you feel it
lock into position. Do not use force.
Fig. 3
Preparation
To remove the Battery Pack 22, press the
Battery Release Buttons 21 and pull the Bat-
tery Pack 22 out of the Battery Port 43. Do
not use force.
Battery Status Indicator
(Fig. 1)
The Battery Charge Indicator 34 on the dis-
play shows the state of charge of the Battery
Pack 22.
the
batteries
Inserting/Changing the Coin Cell
(Fig. 4, Fig. 5)
rectly and fully, stop using the measuring
tool, remove the coin cell and have the
measuring tool repaired.
To be able to save the time on the detection
tool, a Coin Cell 44 must be used.
Unscrew the Screw 45 on the Coin Cell
Holder 46. Pull the Coin Cell Holder 46 out
of the Coin Cell Port 47 with an auxiliary
tool (e.g. a flat-head screwdriver).
Remove the discharged Coin Cell 44 and in-
sert a new Coin Cell 44 (CR2032). Ensure
that the polarity is correct according to the
illustration on the coin cell holder (the posi-
tive terminal of the coin cell must be facing
22
22
upwards).
With the Coin Cell 44 fitted, slide the Coin
Cell Holder 46 into the Coin Cell Port 47.
Ensure that the Coin Cell Holder 46 is in-
43
43
serted correctly and fully, as otherwise pro-
21
21
tection from dust and splashes is no longer
20
guaranteed.
-13-
Indication
Capacity
≥3/4
≥1/2
≥1/4
<1/4
Blinking: ≤1%
If the coin cell holder
cannot be closed cor-
Publicité
