Süd wind Ambientika Solo+ Manuel D'installation Et De Maintenance page 68

MASTER-SLAVE AIR FLOW MODE
To get into this mode, repeatedly press the button FLOW (F) to see the image below on
display.
When pressing FLOW button the mode will change in the sequence MASTER-SLAVE AIR
FLOW, SLAVE-MASTER AIR FLOW, EXTRACTION, INTAKE, MASTER-SLAVE AIR
AIRFLOW...).
In this mode the IMPELLER button (V) is active to select the desired speed.
Remote control
In this mode the units generate a continuous air flow going from MASTER or SLAVE
SAME AS MASTER units to SLAVE OPPOSITE TO MASTER excluding heat recovery.
Advise for use
Recommended mode to isolate odors in a room, like in the kitchen, generating a
continuous air flow towards it.
This is also suitable for use as free-cooling in summer season, in fact when external
temperature is lower than internal one, there is no need to recover heat but to blow
fresh air into the house.
By pressing the specific function button all the units will constantly run in the desired
direction with the possibility to change the speed as required.
Remote panel
68