Süd wind Ambientika Solo+ Manuel D'installation Et De Maintenance page 65

MANUAL MODE
To get into this mode, repeatedly press the button MODE (M) to see the image below on
display.
When pressing MODE button, the mode will change in the sequence (AUTO,
SURVEILLANCE, MANUAL, AUTO, SURVEILLANCE...).
In this mode the IMPELLER button (V) is active to select the desired speed.
Remote control
In this mode the sensors are disabled and the units will run with heat recovery.
The end user can select the desired speed to run the units and this condition remains until
a different command is entered.
Advice for use
Recommended mode when heat recovery is required independently from humidity
levels or when needed to set a fixed speed for all the products.
Remote panel
65