Süd wind Ambientika Solo+ Manuel D'installation Et De Maintenance page 56

INSTALLATION – CONFIGURATION
SOLO
Direct connection, the product doesn't need any configuration.
ADVANCED
For configuration, please follow the instructions below, taking into consideration that the
first unit installed will be the MASTER and all the others in sequence SLAVE OPPOSITE
to MASTER and SLAVE SAME AS MASTER UNIT.
WARNING: the MASTER is the only unit receiving commands from control device, that will
detect the ambient conditions through the sensors and thus controlling all the system.
If you have a remote panel with CO
control panel.
In case of large indoor space or systems on multi-floors, it is recommended to split the
system into zones (living area-sleeping area or 1
units.
sensor, the CO
2 2
st floor-2
56
will be detected directly by the
nd floor) for easier control of the