Publicité
Les langues disponibles
Les langues disponibles
AUTOMATIC MODE
To get into this mode, repeatedly press the button MODE (M) to see the image below on
display.
When pressing MODE button, the mode will change in the sequence (AUTO,
SURVEILLANCE, MANUAL, AUTO, SURVEILLANCE...).
In this mode the HUMIDITY button (H) is active to select the desired threshold. (1 drop
40%, 2 drops 60%, 3 drops 75%).
Remote control
In this mode both humidity and twilight sensors are active, the units will run by themselves
without the need to give commands.
Hereinafter explaining how the units run in different situations with related operating mode:
In standard humidity (or CO
speed and with heat recovery.
In standard humidity (or CO
speed and with heat recovery.
In case of humidity (or CO
medium speed.
In case of humidity (or CO
speed.
The units get into humidity alarm when the MASTER unit detects in the room a humidity
level higher than the set threshold among the three values available (40%, 60%, 75%).
* The CO
value will be detected only if you have a control panel with an integrated CO
2
sensor.
Advice for use
Recommended mode during standard use of product; once the humidity level is set,
the system will run by itself without the need of any further action.
*) conditions during the day the units run at the medium
2
*) conditions during the night the units run at the minimum
2
*) alarm during the day the units run in extraction at the
2
*) alarm during the night the units run in extraction at the night
2
63
Remote panel
2
Publicité
