Mitel 6905 Guide D'installation page 3

Network and Power Connections (See Figure
The Mitel MiVoice 6905 IP phone can be set up as a direct network connection
to the Ethernet wall jack or as a shared network connection as a pass-through
if connecting the phone to a computer or another network device.
NOTE: This product is designed for indoor use only and for ambient
temperatures at or below 40° C (104° F).
NOTE: The phone must be connected only to indoor routed PoE or Ethernet
wiring.
Direct Network Connection
Located on the back of the phone are two fully switched 10/100 Mbps Ethernet
cable ports. The port marked with
network, as well as provide power to your phone (if required).
Shared Network Connection
To connect a network device (such as a computer) to the phone, connect an
Ethernet cable into the network port on the back of the phone marked with
Plug the other end of the Ethernet cable into the network jack on the network
device for which you are sharing the network connection.
NOTE: The PC jack on the 6905 IP phone does not supply inline power onto
other network devices.
NOTE: All Ethernet cables used must be minimum Category 5/5e straight-
through cables.
Connecting to the Network and to Power
If your network provides 802.3af compliant inline power, the phone is powered
through the network.
1. On the back of your phone, connect an Ethernet cable into the network port
marked with .
2. Plug the other end of the Ethernet cable directly into the network jack on
the wall.
If your network does not provided inline power, use the power adapter (sold
separately) with your phone and plug your phone into a power source.
Handset and Headset Connections (See Figure
Connecting a Handset
1. Turn the phone over and locate the handset jack marked
2. Insert one end of handset cord into the jack until it clicks into place.
3. Then route the handset cord through the available grooves (see Figure B).
4. Attach the handset to the other end of the handset cord.
Desk Installation (See Figure
For desk installation of the Mitel MiVoice 6905 IP phone a reversible stand is
included that attaches to the back of the phone above the various ports. Two
viewing angles (30° low angle and 60° high angle) are available allowing users
to personalize their phone viewing preference.
1. Locate the stand insertion area on the back of the phone (above the
various ports).
2. Carefully insert the stand into the insertion area and slide the stand
towards the right until it snaps in place.
The orientation of the stand determines the viewing angle. If the bottom of
the stand is installed facing the top of the phone the viewing angle will be
30°. If the bottom of the stand is installed facing the bottom of the phone
the viewing angle will be 60°.
A )
is used to connect the phone to the
B
)
.
C )
Wall Installation
The Mitel MiVoice 6905 IP phone can be mounted @to a wall using the Mitel
6900 Series Wall Mount Kit (optional accessory). The Mitel 6900 Series Wall
Mount Kit is designed to be used with all 6900 Series IP phones allowing you to
easily and securely mount your phone in one of two ways:
• Directly to the wall
• On top of an existing telco wall plate
NOTE: Refer to the Mitel 6900 Series Wall Mount Kit Installation Guide for
additional product and installation details.
.
3