Publicité
Les langues disponibles
Les langues disponibles
CLEANING AND MAINTENANCE
1. C
HANGING THE BAG
• The bag capacity indicator (5) tells you
when
the
bag
If you notice that your vacuum cleaner is less
efficient, select the maximum power and by
lifting the floor head off the floor. If the
indicator remains red, replace the bag.
fig. 13
• Open the lid (9) of your vacuum cleaner
.
• Withdraw the bag support (18)
fig. 15
Unclip the bag (20) by pressing the lever
, Throw the bag into the dustbin -
fig. 17- 18 -19
or empty the washable textile bag (17) -
• Fit a fresh bag, position it using the tongue
fig. 20
provided and clip it onto the bag support
- fig. 21
. Slide the bag support back onto the
- fig. 22
runners
place the bag inside the
compartment
• When the washable textile bag (17) is very
dirty, wash it under running water and leave
to dry for 24 hours.
• Make sure that the bag is in the correct
position before closing the lid (9).
2. C
LEANING THE FOAM FILTER FOR PROTECTION
OF THE MOTOR
• The foam filter protecting the motor (12) must
always remain in place during use.
• Open the lid (9). The grid (13)
remove the foam-filter (12)
• Shake it and clean it, every ten dustbag
changes, with tepid soapy water.
• Rinse, dry and put it back in place.
• Let the foam-filter dry (12) completely before
putting back in place.
• Rinse it and leave it to dry for at least 12 hours
before putting it back.
Attention: ensure that the foam filter is
properly dry before putting it back
3. C
HEPA
HANGE THE
HEPA
WASHABLE
FILTER CAPSULE
MICRO FILTER CAPSULE
CHANGE OR CLEAN THE BAG
3.1- The HEPA* filter cassette
fig. 13
• Open the lid (9) of your vacuum cleaner
.
• Remove the Hepa* filter cassette (15)
and dispose of the cassette in a waste bin.
• Fit
the
new
Hepa*
is
full
or
saturated.
- fig. 14
fig. 16
.
- fig. 23
- fig. 24
then
.
*,
FILTER CAPSULE
THE
*
OR THE
*
10
EVERY
TIMES YOU
- fig. 25
filter
cassette
fig. 28
(ref. MT0001 01) (15) in its compartment
.
• Check that the Hepa* filter cassette (15) is
fitted correctly before re-closing the lid (9).
• Change the HEPA filter cassette every 10
times you change the bag
-
3.2- Washable HEPA filter cassette* (for
appliances with a textile bag).
fig. 13.
• Open the lid (9) to your vacuum cleaner
-
;
- fig. 25
• Remove the washable HEPA filter cassette
(14)
, tap the side without the grid
on the side of the dustbin
• Wash the cassette under running water and
-
leave to dry for 24 hours
• Replace the washable HEPA filter cassette
(17) ref. MT0004 01 in its housing
• Clean the washable HEPA filter cassette
every 6 months.
3.3- The microfilter cassette*
fig. 13
• Open the lid (9) of your vacuum cleaner
.
25.
• Withdraw the microfilter cassette* (16)
• Separate the grey foam filter (16b) from the
microfilter (16a).
• Dispose of the microfilter (16a) in a waste bin
and replace it with a new Microfilter (ref.
MT0001 01).
• Wash the grey foam filter (16b) with warm
soapy water (mild detergent). Squeeze it out
and leave it to dry for at least 12 hours.
Caution: Make sure that the grey foam filter
is completely dry before putting it back in
place.
• Re-fit the grey foam filter (16b) to the
microfilter (16a).
• Re-fit
the
microfilter
compartment (16)
• Check that the microfilter cassette* (16) is
fitted correctly before re-closing the lid (9).
• Change the microfilter every 10 times you
change the bag.
4. C
LEAN THE VACUUM CLEANER
-
• Clean the housing of the vacuum cleaner
with a soft and humid rag and let dry.
• Clean the cover with a dry rag
• Do not use abrasive or aggressive products.
- fig. 26.
- fig.27
.
- fig. 28.
- fig.
- fig. 28
cassette*
in
.
- fig. 29
.
F
GB
I
-
E
P
SA
-
FA
TR
-
its
11
Publicité
