Bosch NIT5068UC Mode D'emploi page 18

Noises
Crackling:
Occurs when using cookware made from different layers of material or when using cookware of different
sizes and different materials at the same time. The volume of the noise can vary depending on the quantity
of food being cooked or the cooking method.
High-pitched whistling noises:
Can occur when two elements are used on the highest heat setting at the same time. The whistling noises
disappear or become quieter when the heat setting is reduced.
Fan noise:
The cooktop is equipped with a fan that switches on automatically at high temperatures. The fan may con-
tinue to run even after you have switched off the cooktop if the temperature detected is still too high.
Cleaning
How do I clean the cooktop?
Using a special glass-ceramic cleaning agent produces the best results. We advise against using harsh or
abrasive cleaning agents, dishwater detergent (concentrated) or scouring pads.
You can find more information about cleaning and caring for your cooktop in the section on
Fixing Malfunctions
Malfunctions are usually due to small details. Before
calling the Technical Assistance Service, you should
consider the following advice and warnings.
Display
None
The displays flash
The indicator flashes
Ù
in the element displays
"ƒ
"...
+ heat setting and
"†
acoustic signal
and acoustic signal
"†
/
"‚ "‡
Do not place hot pans on the control panel.
18
All manuals and user guides at all-guides.com
Possible cause
The power supply has been discon-
nected.
The device has not been connected in
accordance with the connection dia-
gram.
Electronics error.
The control panel is damp or an
object is covering it.
An error has occurred in the electron-
ics.
The electronics have overheated and
have switched off the corresponding
element.
The electronics have overheated and
have switched off all elements.
There is a hot pan in the area of the
control panel. There is a risk that the
electronics will overheat.
There is a hot pan in the area of the
control panel. To protect the electron-
ics, the element has been switched
off.
The element has overheated and
switched itself off to protect the work
surface.
CAUTION
9
Repairs should only be done by an authorized
servicer.
Improper repair of your appliance may result in risk
of severe physical injury or death.
Solution
Use other electrical devices to check whether a
short-circuit has occurred in the power supply.
Ensure that the device has been connected in
accordance with the connection diagram.
If the error cannot be eliminated, inform the techni-
cal after-sales service.
Dry the control panel or remove the object.
To confirm the error, cover the control panel with
your hand.
Wait until the electronics have cooled down suffi-
ciently. Then touch any symbol on the cooktop. If
the warning persists, call the Technical Assistance
Service.
Remove the pan. The error display goes out shortly
afterwards. You can continue to cook.
Remove the pan. Wait for a few seconds. Touch
any control. If the error display goes out, you can
continue to cook.
Wait until the electronics have cooled down suffi-
ciently and switch the element on again.