Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
KDP8 - 2/3 wires detector
Motion detector wall switch
Troubleshooting
When KPD1 works abnormaly, please check assumptive problems and
suggested solutions in following table that will hopefully to solve your
problem.
Problem
Possible cause
Load does
1.Wiring is connected
not turn on
incorrectly.
2.Malfunctioned load.
3.Meter setting is too short.
4.The slide switch is at OFF.
Load does
1.TIME setting is too long,
not turn off
detector is continuously
triggered.
2.Detector is nuisance
triggering.
3.Wiring is connected
incorrectly.
Push button
1. Incorrect time setting
does not
2.Detector is nuisance
work.
triggered.
3. Wired incorrectly.
Nuisance
There are heat sources,
triggering
highly reflective objects or
any objects which may be
swayed in the wind within
the detection coverage.
Instructions manual |
32
Suggested solution
1. Please check whether the
power supply and load are
connected correctly or not.
2.Replace the malfunctioned
load with a new one.
3.Setting METER at "+".
4.Adjust slide switch at AUTO
or ON.
1.Setting TIME at "-" .
2.Keep away from detection
zone to avoid activating
detector while doing the test.
3.Please check whether the
power is supplied and load is
connected correctly or not.
1.Please check if the push
button is connected between
T and L.
2.Replace the push button
with a new one.
Avoid aiming the detector
toward any heat sources,
such as air conditioners,
electric fans, heaters or any
highly reflective surfaces.
Make sure there are no
swaying objects within the
detection coverage.
www.grupotemper.com
Publicité
