koban KDP8AH Mode D'emploi page 57

KDP8-2H
Single sensor wall switch wiring (See FIG.9).
Two sensor wall switches paralleled to control the connected load (See
FIG.10).
Note:
To connect conductive load, please make X
(100Ω, 2W) paralleled between terminal N and L' (See FIG.8 & FIG.9).
Installation procedure
Note:
• Please read the instruction manual carefully before installation.
• Shut off all the power supply.
KDP8 can be fixed on the wall either by
European standard junction box or by
JB-40.
The existing 2-gang switch or more,
the internal size of plastic frame is 50 x
50MM, can be replaced by KDP8 (See
FIG.11).
www.grupotemper.com
All manuals and user guides at all-guides.com
KDP8-3H
KDP8 - 2/3 wires detector
Motion detector wall switch
KDP8-3H
KDP8-3H
capacitor (0.22μF) and R resistor
2
Instructions manual | 25