Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
KDP8 - 2/3 wires detector
Motion detector wall switch
Test procedure
• Switch the power on.
• Walk from outside across to the detection pattern,
once the detector is triggered, LED and load will all
turn on for 6sec.
• Adjust METER knob to reach desired coverage.
• Adjust TIME knob to change the switch off delay
time.
• Refer to point " Usage of lens shield label", detection
range and angle can be changed by adjusting lens shield label.
• Repeat this steps until it meets user's demands.
• Pay attention to the walking direction while proceeding the test (See FIG.5).
Manual switch function
AUTO : Set slide switch in the middle, detector is in AUTO mode.
OFF : Push the slide switch leftward, "O" icon appears at right, detector is in
OFF mode, the connected lighting keeps permanent OFF.
ON : Push the slide switch rightward, "I" icon appears at left, ON mode is
activated, the connected lighting keeps permanent ON (See FIG.19).
Instructions manual |
30
www.grupotemper.com
Publicité
