Publicité
Les langues disponibles
Les langues disponibles
• Push the cap onto the housing until it
snaps securely into place.
REWINDING SPOOL FROM BULK LINE (USE
ONLY .065 IN. ROUND DIAMETER LINE)
Bulk line is also available for purchase
from your local retailer. NOTE: Hand
wound spools from bulk line are likely
to become tangled more frequently than
BLACK+DECKER factory wound spools.
For best results, factory wound spools are
recommended.
To install bulk line, follow the steps below:
• Remove battery from appliance.
• Remove the empty spool from the
appliance as described in "REPLACING
THE SPOOL."
• Remove any remaining cutting line from
the spool.
• Make a fold at the end of the cutting line
at about 3/4 inch (19mm)(26). Feed the
cutting line into one of the line anchoring
slots (27) as shown in figure R.
R
27
• Insert the 3/4 inch (19mm) end of the
bulk line into the hole (28) in the spool
adjacent to the slot as shown in figure S.
Make sure the line is pulled tight against
the spool as shown in figure S.
S
29
• Wind the cutting line onto the spool in
the direction of the arrow on the spool.
Make sure to wind the line on neatly and
in layers. Do not crisscross (figure T).
• When the wound cutting line reaches the
recesses (29), cut the line. (figure S).
• Fit the spool onto the
appliance as described in
"REPLACING THE SPOOL".
All manuals and user guides at all-guides.com
MAINTENANCE
remove the battery from the appliance
before performing any maintenance.
1. Keep the air intake slots clean to avoid
2. Your trimmer line can dry out over time. To
3. Plastic parts may be cleaned by using a
26
4. The line cutter on the edge of the guard
IMPORTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance
and adjustment should be performed
by authorized service centers or other
qualified service organizations, always
using identical replacement parts.
This Class B digital apparatus complies
with Canadian ICES-003.
This device complies with part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
28
received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
11
T
WARNING:
To avoid serious injury,
overheating.
keep your line in top condition, store spare
pre-wound spools or bulk line in a plastic,
sealable bag with a tablespoon of water.
mild soap and a damp rag.
can dull over time. It is recommended
you periodically touch-up the sharpness
of the blade with a file.
Publicité
