Whittier Wood Products 225W Instructions De Montage page 5

FIG. 4
4. Attach Top Shelf (A) to Left Side Panel (B) sliding the Rafix Bolts (J) into the Rafix Cams (I).
Tighten the cams. Repeat to attach the Right Side Panel (C) to the Top Shelf (A). Attach the
Crown (D) in the same way tightening the Cams to hold it to the Top.
5. Carefully turn the unit over on its face with the top up on a protective surface. Install the Bottom
Shelf (E) sliding it over and down onto the Rafix Bolts (J). Tighten the cams. In the same way
install the Back Support (F) sliding it onto the Rafix Bolts (J) in the lower back corners of each
side panel. Make sure the rounded edge of the Back Support (F) is facing up and towards the
front of the unit. Tighten the cams. See FIGURE 5.
K
x 18
FIG. 6A
6. With the unit laying face down on a protective surface, measure from top left to bottom right
( ) and from bottom left to top right (
is longer, tap bottom of Left Side Panel (B) until measurements are equal. If line (
tap bottom of Right Side Panel (C).
Unfold the Back (G) and attach to the unit using Screws (K). Make sure the top edge of the back is
flush with the top edge of top shelf and equal distance from the sides.
All manuals and user guides at all-guides.com
). Measurements should be equal. If the line (
E
F
FIG. 5
FIG. 6B
)
) is longer,
225W/226W — Page 5